I need urgent help with my network design. I have put forward 2*WS-C3750E-24TD-E switches in the design. I have ordered it and now have found that it comes with 265W power supply. The problem is I have also ordered PWR-RPS2300 with 2*C3K-PWR-750WAC, thought of supplying back up power incase AC fails. Here is my question, is this switch with 265W PSU can be backed up with 750W PSU or in other way is 265w PSU compatible with 750w PSU.
Just an input here , the RPS2300 is not a backup power source per se , it is used to back up the the internal power supply in say the 3750 if the internal power supply of the 3750 fails for some reason . To have actual power backup capability you still need a UPS hooked to these RPS2300's .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...