Guys i have one 3350 switch and two routers cisco 878.....the routers are attached to the swicth via LAN (layer 2) ports of the router (which is builin) now i have created 2 vlans 10,11 on the 3350 swicth and assigned the port to it (which connects the routers) now i want to ping one router from other (different Vlans) can someone please tell m ehow it will be as the swicth port in the router is layer two i cant assignm IP address and my design required that the router shd connect to the swicth via layer 2 port which is builtin???? what shd i do can someone please help
If you want to be able to communicate between the 2 routers then either
1) You need both routers to have their interfaces in the same vlan and allocate an IP address for each router interface out of the same subnet
2) You need to enable inter-vlan routing on your 3550 switch to route between the 2 vlans. If your switch is running SMI software it can only act as layer 2 switch. If it is running EMI software you make it responsible for routing between the 2 vlans.
my swicth is EMI and i have created two vlans interfaces as well as vlans on them......now my one router shd be in one vlan and the other should be in other.....the inbuilt swicth port from both the routers are connected to swicth and i have mak ethe swicth ports of 3550 meeber of vlans already the problem is how i am going to configure the routers to ping each other i have no problem with 3550 or how i m gonna configure inter vlan routing.......what shd be configs on routers????
so it means that i have to create vlan interfaces on the router as well??? as the cable is attached to swicth port which doesnt take any ip address???? it has lan interface but our design says that it shd be attached to the 4one of the 4 switch ports???
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.