Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Urgent - upgrade DRAM

I am in the process of upgrading the RAM on a at Cat 6509. I have replaed the DRAM as instructed but doing show version still shows the same old value

I am upgrading from 128M to 512M. I need it to be 512M so that it can take a new card

cisco WS-C6509 (R7000) processor (revision 3.0) with 112640K/18432K bytes of memory.

Processor board ID SAL0720D9PF

R7000 CPU at 300Mhz, Implementation 39, Rev 3.3, 256KB L2, 1024KB L3 Cache

Last reset from power-on

X.25 software, Version 3.0.0.

Bridging software.

1 Virtual Ethernet/IEEE 802.3 interface(s)

288 FastEthernet/IEEE 802.3 interface(s)

4 Gigabit Ethernet/IEEE 802.3 interface(s)

381K bytes of non-volatile configuration memory.

32768K bytes of Flash internal SIMM (Sector size 512K).

Standby is up

Standby has 112640K/18432K bytes of memory.

Configuration register is 0x2102

Thanks

Where should it show the 512M?

1 REPLY
Hall of Fame Super Bronze

Re: Urgent - upgrade DRAM

It should show on this line:

cisco WS-C6509 (R7000) processor (revision 3.0) with 112640K/18432K bytes of memory.

And you still have 128MB

I recommend following this article:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_12409.html

HTH,

__

Edison.

114
Views
0
Helpful
1
Replies