I have a Cisco 3500 with 48 port and 2 uplink ports. When i use a fastethernet port as uplink i get the following error:
"%SPANTREE-2-BLOCK_PORT_TYPE: Blocking FastEthernet0/42 on vlan 1.Inconsistent port type." and the port is disabled. I tried several spanning-tree modes and mode trunk on that port but it is still not working. I cleared the configuration from the switch before i started. The two other uplink port working fine but on that location we don't have glassfibre. :-(
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.