Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Use of Linecard 10G on a 6513 non-e with supervisor sup720-3B

Hi Folks,

My customer wanna buy an additional module "6704-10G" for use on a switch 6513 non-e slot 12, the only empty slot from the range 9-13 (dual channel for 40G). My customer supervisor is sup720-3B and he told me that a Cisco employee told him that his switch is not allowed to have one more 10G linecard due to hardware limitations, but I haven't found any Cisco documentation that affirm it. So, I just wanna to confirm if there is some kind of limitation for use linecard 6704-10G on slot 12.


------------------ show module ------------------


Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 8 Network Analysis Module WS-SVC-NAM-2 SAD094503KT
2 8 8 port 1000mb GBIC Enhanced QoS WS-X6408A-GBIC SAL09475UVG
7 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL094979Q4
8 2 Supervisor Engine 720 (Hot) WS-SUP720-3B SAL09486FEJ
9 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX SAL09486T86
10 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX SAL1708ZDBL
11 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX SAL094239TS
13 4 CEF720 4 port 10-Gigabit Ethernet WS-X6704-10GE SAL09454RZ1

Everyone's tags (6)
3 REPLIES
Hall of Fame Super Gold

Your 6704-10G should only be

Your 6704-10G should only be installed only in slots 9 through 13 in a Cisco Catalyst 6513 or Cisco 7613 chassis.

 

Refer to Table 1 here.

New Member

Leo, tks for answer!I have

Leo, tks for answer!

I have commented that from slots slots 9 through 13 my customer only have slot 12 available, but he said an Cisco employee warned that it would be impossible to use an additional module 10G because the equipment would not support. However based on documents I have found and you (Leo) shared appear not to be true and chassis+sup really support a new 10G linecard on slot 12.

Is it correct?

Tks!

Hall of Fame Super Gold

If you want an official

If you want an official response, generate a Cisco TAC out of this thread.

113
Views
0
Helpful
3
Replies