09-26-2008 03:19 PM - edited 03-06-2019 01:37 AM
We just got a new Sup720-10g in that runs 12.2(33)SXH3 and after configuring it similar to our other switches, it prompts for a username on both the initial SSH login and when going to enable mode. Normally I only get a password prompt when going to enable mode and a username/password prompt for unpriviliged mode.
Anybody seen this behavior before?
Thx
Mark
Solved! Go to Solution.
09-26-2008 08:07 PM
There is a known defect for this issue
09-26-2008 08:07 PM
There is a known defect for this issue
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide