Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using filtered output as a command parameter.

I want to dump the contents of the ACL applied to the vty section regardless of name or ID by using the filtered output of another command but I can't seem to find the right syntax.  Does the subshell the feature that would allow me to do this? If not, in addition to the help above do you have a good example of a non-invasive use of the subshell?  I've searched all over but I can't seem to find anything that helps.  I've attempted the command below without success.

show ip access-list {!|:![show run | section vty | inc class | cut -d ' ' -f 4}

Everyone's tags (4)
149
Views
0
Helpful
0
Replies
CreatePlease login to create content