Can I use the backup interface command with eigrp ? will this stop the updates bringing up the line? or is floating static routes the only option in this case, has anyone got an example config with eigrp ?
Carl, after 2239 posts, how much have you learned? Previously you stated that you are educating yourself using this forum. I have nothing against that but meanwhile I have the impression that you are one of those who will never learn anything! For a start, you still haven't learned to rate posts that are helpful to you and that would be the least to do for someone who is using this forum so intensively.
I CANNOT UNDERSTAND THAT THERE ARE STILL PEOPLE THAT ARE WILLING TO ANSWER YOUR SILLY QUESTIONS. I suppose this is solely due to the massive amount of knowledgeable people around that are not yet completely flabbergasted with your stupidity!
Therefore once again, I solemnly ask you to start rating posts; it is the least you can do for those who are still bothering to answer your oneliners. For the rest I wish you all the best, you need it!
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...