I need to monitor network traffic going through a 4006 switch running CAT OS. All traffic is on VLAN 1. I have a port sniffer PC setup and connected to two ports on this switch, the sniffer is on port 6/2, I want to direct all traffic through this port so it can be monitored. So far I have not been able to make it work. I have the following code in place but it is not working:
switch port analyzer
set span 1 6/2 both inpkts enable learning enable create
Let me know if you need the entire config posted. Anyone have ideas?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...