On the Sup1a just use the "show traffic " command and this will give backplane utilization . On the msfc use " show proc cpu sort " and if the code is new enough "show proc cpu history" and this will give you 3 little sets of graphs , one will give a graph of the cpu for the last 72 hours . . This should be fairly low as most traffic is hardware switched and never hits the layer 3 CPU .
You can use the sh proc cpu command, but this result will not be completely accurate as forwarding decisions are made in hardware, not software, in the switch. It will give you a general idea, but the CPU utilization most likely will not increase in proportion to the amount of traffic being passed as the hardware will be making these decisions as well and there is no detailed way to get this information.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.