i dont think there is any CLI command to display the backplane utilization.
THe 6500 has a MIB which can be used to get information about backplane utilization.
Other Catalyst switches that run Cisco IOS Software are based on a different architecture. Therefore, you are not able to get the backplane utilization for them. With these devices, you can determine the performance of the switch from the utilization of the CPU and bandwidth of its interfaces
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...