Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Utilzation on Cisco 6513 switch

Had a partner doing backups acoss the network between a 3750 and 6513 core switch ove a gigabit backbone. it looks like this caused issues with other connections through the 6513. It looks like the gigabit port was going up to 10MB which does not seem that high. I would see time outs on pings when we stopped the backups it looks like the problem may have gone away. i have been looking for commands to use on the 6513 to see utilzation for the cpu and ports to troubleshoot this.

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Utilzation on Cisco 6513 switch

show proc - will give you cpu util for :-

5 seconds - 1 minute - 5 minutes

sh int gig x/x accounting

sh int gig x/x counters

show int gig x/x

All will give good stats etc.

HTH>

Re: Utilzation on Cisco 6513 switch

1.For CPu utilization

"show process cpu | exclude 0.00"

2.For interface regular commands like

"show interface ***"

Look for load,input rate,output rate

Clear the counters , before starting monitoring the interface.

3.Other option is Netflow

HTH..rate if helpful..

3 REPLIES

Re: Utilzation on Cisco 6513 switch

show proc - will give you cpu util for :-

5 seconds - 1 minute - 5 minutes

sh int gig x/x accounting

sh int gig x/x counters

show int gig x/x

All will give good stats etc.

HTH>

Purple

Re: Utilzation on Cisco 6513 switch

Use show proc cpu sort and it will sort from highest to lowest the functions that are using the cpu. In a 6513 most traffic should never hit the cpu , if it is then you have a problem .

Re: Utilzation on Cisco 6513 switch

1.For CPu utilization

"show process cpu | exclude 0.00"

2.For interface regular commands like

"show interface ***"

Look for load,input rate,output rate

Clear the counters , before starting monitoring the interface.

3.Other option is Netflow

HTH..rate if helpful..

145
Views
5
Helpful
3
Replies