I have just set up a VACL capture on a 6509. I am able to see ip traffic on vlan but am unable to see any ICMP traffic. Three questions.
1. If i want to make changes to a VACL that is capturing, do i need to somehow reset or reload the VACL in memory before the changes take effect? I ask this because i did not have a "permit icmp any any" in the VACL at first but then added it which did not start capturing ICMP.
2. Is a VACL just simply unable to capture ICMP?
3. For VACL capture to work does that VLAN's SVI need to live on the switch that is capturing? In otherwords, could i capture on a VLAN that uses its default gateway in a FWSM?
Thanks for all your help guys. I have spent a fair amount of time digging for these answers and was hoping somebody could help me out!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...