not sure if this is the right community to post this kind of question but i am after some example of vbscripts to detect routing change for example like to know when someone add a new route entry, advertised in to our campus networks, would like to know the no of routing entries being added, now of routes in the routing table /etc including vlan changes, RPF failures within the environment and number of entries in our multicast table including new additions.
any example you can provide will be useful. thanks in advance.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...