Hi, I have a 877w running IOS C870-ADVSECURITYK9-M, Version 12.4(24)T2. For some reason I cannot get my wireless speed to go above 1.1MB/s.
Both NICs on my notebook and media centre are set for 802.11g. I also brought a 3rd computer into the mix and tried doing throughput tests between my own two computers to find I was getting the same speeds which indicates to me that the router is at fault.
Here is the wireless component of my config, can anyone see where I might improve it to get some decent throughput?
interface Dot11Radio0 no ip address no ip route-cache ip tcp adjust-mss 1400 no dot11 extension aironet ! encryption mode ciphers aes-ccm ! ssid LOZZAIR ! speed basic-54.0 station-role root world-mode dot11d country AU indoor no cdp enable bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.