Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

View/modify DSCP-to-txqueue maps on 4500X running IOS-XE?

Hi,

I am running IOS-XE 03.04.03.SG (15.1(2)SG3) on a Catalyst 4500X-32 and try to configure some QoS for voice and data. I cannot find a way to view or modify the DSCP to egress queue maps though.

I went through the config guide and looked everywhere but no success. Am I missing something?

 

Thanks in advance,

Jan

3 REPLIES

Hey Jan,In sup6 and above the

Hey Jan,

In sup6 and above the maps are supported in MQC way. Please have a look on the link given below:

http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Video/qoscampuscat4500aag.pdf

HTH.

Regards,

RS.
 

New Member

Hi RS,Thank you for your

Hi RS,

Thank you for your answer, and sorry for not getting back to you sooner.

I'm afraid this document tells me nothing new. It indeed states how to configure the queueing etc, but I still miss a way to view the DSCP (or cos) to queue mappings.

 

Jan

New Member

Hi, After searching the half

Hi,

 

After searching the half of the web I found that on Catalyst 4500 the (reverse) order of configuring classes within the policy-map determines the queue for each class. Besides the priority class (always first queue 0) and the default class (always last queue 7), the first configured class will take the second to last queue (queue 6), the second class will take the third to last queue (queue 5), and so on.

For example:

Policy Map AutoQos-VoIP-Output-Policy
 Class AutoQos-VoIP-Bearer-QosGroup
   set dscp ef
   set cos 5
   priority
  police cir percent 33
    conform-action transmit 
    exceed-action drop 
 Class AutoQos-VoIP-Control-QosGroup26
   set dscp af31
   set cos 3
   bandwidth remaining percent 5
 Class AutoQos-VoIP-Control-QosGroup24
   set dscp cs3
   set cos 3
   bandwidth remaining percent 5
 Class class-default
   dbl

 

Will result in:

Queue 0: Class AutoQos-VoIP-Bearer-QosGroup (priority)

Queue 7: Class class-default

Queue 6: Class AutoQos-VoIP-Control-QosGroup26

Queue 5: Class AutoQos-VoIP-Control-QosGroup24

 

I tested this on a Catalyst 4500 and can confirm this.

No idea why this is not well documented, or was I just looking in the wrong place?

- For the record: the place where I found this answer is p70 at http://d2zmdbbm9feqrf.cloudfront.net/2012/usa/pdf/BRKCRS-3142.pdf

 

Regards,

Jan

191
Views
0
Helpful
3
Replies
CreatePlease login to create content