Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Viewing config on standby sup720

Hi,

I have a 6500 with two sup720's installed they are in an active and standby state.

They are both running in a hybrid mode using CatOS cat6000-sup720k8.8-3-6.bin & c6msfc3-psv-mz.122-17d.SXB9.bin on the MSFC3

My question is, is there anyway to view the CatOS config on the standby card ?

We have recently swapped the standby card out for a replacement and I would now like to view the config on it to see if the active card has synced the config over correctly ?

Thanks in advance.

Rich

1 REPLY
Silver

Re: Viewing config on standby sup720

Use show tech commands. You will get the info.

137
Views
0
Helpful
1
Replies
CreatePlease to create content