Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Virtual Port Channel on different line cards problem

Hi,

It is possible to add interface from different line cards reference ( for example N7K-148GT-11L and N7K-F132XP-15 ) to a vPC ?

I ask you because I try it and I have the following error :

command failed: port not compatible [Capabilities FabricPath]

Thank you,

Thibault

1 REPLY
Cisco Employee

Virtual Port Channel on different line cards problem

Hi Thibault,

no, unfortunately you cannot mix M1 with F1 ports within the same portchannel (not necessarily vPC).

It is documented here:

http://cco/en/US/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_portchannel.html#wp1888267

'You cannot configure the ports from a F1 and an M1 series linecard in the same port channel because the ports will fail to meet the compatibility requirements.'

regards,

Riccardo

1200
Views
0
Helpful
1
Replies
CreatePlease to create content