Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Vlan 1 on 2924-xl

I have tried to block Vlan 1 on a port fa 0/1 trunk of a Catalyst 2924-XL.

I have entered :

switch#(config-if)switchport mode trunk

switch#(config-if)switchport native vlan 2

switch#(config-if)switchport trunk allowed vlan 2

Unfortunately I see again vlan 1 on this trunk

Can I block it on Catalyst 2924-XL ?

bets regards

Lorenzo

4 REPLIES
bjw Silver
Silver

Re: Vlan 1 on 2924-xl

I do not think you can eliminate/disable vlan 1 it carries carries the spanning tree traffic and other special purpose trunk info.

If you don't explicilty assign it ip addressing info you should be ok. All native vlan 2 does is transfer vlan 2 frames untagged.

New Member

Re: Vlan 1 on 2924-xl

Hi,

I know, but with C2950-24 I can do it,

I can block vlan 1 on trunk to any port

fastethernet, provided that I configure another native vlan for that port.

Can you tell me about it ?

Best regards

Lorenzo

bjw Silver
Silver

Re: Vlan 1 on 2924-xl

Lorenzo, the 2900XL and 3500XL series boxes are slightly different creatures. Example:

Switch>(config)switchport trunk allowed vlan remove vlan-list

The " remove vlan-list" valid variable range is 2-1001, also the pruneeligible list accepts only 2-1001.

I don't have access to a 2900XL, but you might want to see if there's a later IOS release that addresses this.

Have you tried to Shutdown interface VLAN1 and see if it takes?

My ref:

http://www.cisco.com/en/US/products/hw/switches/ps637/products_configuration_guide_chapter09186a00800d9d3e.html

New Member

Re: Vlan 1 on 2924-xl

yes ,

it he same also if I shutdown Vlan 1.

Perhaps 2950 and 2900 are really difference.

I have installed the last IOS for my 2924-XL

but don't change never.

best regards

Lorenzo

313
Views
0
Helpful
4
Replies