I have a Netapp SAN device connected to a workgroup switch (linksys). We just purchased a 4948 and I am looking to VLAN 4 ports on the 4948 for our NETAPP and exchange servers. Can anyone help me with best practices or a best way of doing this? My idea is to VLAN the 4 required ports and simply configure the larger MTU size (jumbo frames) on this switch.
"I am looking to VLAN 4 ports on the 4948 for our NETAPP and exchange servers." does this mean just add those port to a particular vlan or create a vlan interface in the switch specifically for this vlan?
Ullas no i dont have a vlan created yet. I would have to create one. My concerns are more along the line of "is this the best most efficient method?" when dealing with storage and switch config. In other words does creating a VLAN, configuring jumbo frames, and then tagging the ports = a better method than ?????
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...