i have one access switch (2960)which is connected to core switch(4506)and trunk is enabled on both the switches for connected ports, if i will remove the trunk command from my access switch and i'll put access switch connected port on core switch in vlan10, will i be able to access vlan 10 from my access switch?
If I understand your post correctly you currently have an access switch connected to a core switch. As of now both switches are configured to treat the connection as a trunk. I believe your question is that if you change the configuration and both the access switch and the core switch treat the connection as an access port, and if the core switch has assigned that access port connected to the access switch as being in VLAN 10 could the access switch then access VLAN 10. The answer to that question is yes. If it is an access port in the core switch then the switch connecting to that access port will be operating in VLAN 10.
If I have not understood some part then please clarify.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...