VLAN Capabilities for Cisco 2801 w/2-4 port 10/100 switch interface cards
OK. I should know this, but having not worked with integrated service routers before I need to double-check...... Can a 2801 ordered with 2 x Four port 10/100 Ethernet switch interface cards (HWIC-4ESW) be configured with 4 VLANs and route between them?.....the specifics are VLAN-1 w/2 devices attached, VLAN-2 w/1 device attached, VLAN3 w/3 devices attached and VLAN4 w/2 devices attached?.... This would be a much cleaner config then Switch..(tunked to)..router...(truned to)....switch. It seems like the integrated services router could do all that trunking and routing between VLANs internally. But just have never set this up in an integrated services router before so need to be really sure before ordering like 6 of these for this...Visio diagram attached detailing the logical (internal assumption of how the 2801 would work) as well.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...