Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VLAN Config

Given a scenario where in an L3 switch i have 8 ports. I want to make all the ports to be in an different Vlan. Now I have port number 1 as the main port or the port with which all the ports should communicate i.e. trunk port. My question is, Is there a way by which i use routing to redirect the traffic of all the other Vlans or port towards the main port i.e. trunk port.

Please note that i want to use only IP routing and not vlan trunking

New Member

Re: VLAN Config

explain in detail.if possible config pls

Re: VLAN Config

Please explain your requirement again.What exactly you are looking for. You can have all the ports in different vlans but you need to configure the L3 interface for each vlan on your l3 switch to have these ports communicate with each other. Do you want all these ports to communicate with each other? Do you want them to talk to trunk port only? Explain your need in detail.


-amit singh