Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VLAN configuration

hi please help me, how can i configure VLAN to 3550 switch to connect 2960 switch?

im planning to use VTP? i have 3 switched connected tot he 3550 but i need only 1 VLAN for 2960 (with 10 users connected).

can you please tell how to do the configuration.

thanks.....

3 REPLIES

Re: VLAN configuration

Do you mean to say that on one switch you do not need to have all the 3 vlans.

In that case you can allow only the particular vlan on the trunk connecting to 2960

on 3550

interface x/x --- connecting to 2960

switchport trunk encap dot1q

switchport mode trunk

switchport trunk allowed vlan --- vlan u want on the 2960

HTH

Narayan

New Member

Re: VLAN configuration

hi royalblues,

do i need to use different subnet for my 2960 VLAn and use VTP for my 2 2950 and 1 2960 switch?

Silver

Re: VLAN configuration

Hi Iceman ,

3550 :

Int vlan 10

ip address 10.10.10.x 255.255.255.0

no sh

int g0/30

switchport mode trunk

switchport trunk allowed vlan 10

2960 :

int vlan 10

ip address 10.10.10.254 255.255.255.0

no sh

int f0/48

switchport mode trunk

switchport trunk allowed vlan 10

ip-deafult gateway 10.10.10.1

In this case only vlan 10 is allowed between the switches.

Thanks,

satish

125
Views
4
Helpful
3
Replies
CreatePlease login to create content