You are getting a layer 2 vlan and a layer 3 svi mixed up . As previous poster said this is a layer 2 switch only so the only reason to have an SVI defined is to manage the switch. I'm assuming it already has a l3 SVI to manage it so I would leave that alone and delete the layer 3 svi for vlan 97. Seeing that there are so many vlans on the switch that means you have a trunked link somewhere to the L3 device which does the routing . You already have a L2 vlan defined for vlan 97 as shown in the show vlan command so you should be set to go . If you need routing for this subnet it is done on another device that is attached via a trunk .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...