Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Vlan creation on a 2960 poe 24 port

                   I need to create a vlan on a catalyst 2960 switch, create an interface for the vlan that will be a gateway to the vlan. The interface should also have the ip address-helper command to use the DHCP scope which I  have already created on the switch. Then I need assign a port to the vlan in trunking mode.

Can anyone help?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Vlan creation on a 2960 poe 24 port

Here is an example with vlan 100.

I need to create a vlan on a catalyst 2960 switch

config t

vlan100

exit

create an interface for the vlan that will be a gateway to the vlan

config t

inter vlan 100

ip address 192.168.1.1 255.255.255.0

ip helper-address x.x.x.x.

no sh

exit

interface gix/x/x

switchport

switch vlan 100

interface gix/x/x

switch trunk allowed vlan add 100

HTH

2 REPLIES
VIP Super Bronze

Vlan creation on a 2960 poe 24 port

Here is an example with vlan 100.

I need to create a vlan on a catalyst 2960 switch

config t

vlan100

exit

create an interface for the vlan that will be a gateway to the vlan

config t

inter vlan 100

ip address 192.168.1.1 255.255.255.0

ip helper-address x.x.x.x.

no sh

exit

interface gix/x/x

switchport

switch vlan 100

interface gix/x/x

switch trunk allowed vlan add 100

HTH

Community Member

Vlan creation on a 2960 poe 24 port

Thanks Reza

135
Views
5
Helpful
2
Replies
CreatePlease to create content