Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VLAN.dat on 6509

I don't have a PC flash card in our 6509 anymore and I'm trying to make VLAN changes. When I do the "dir vlan.dat" command I get "%Error opening slot0:/vlan.dat (No such device)". Is there a way I can specify the location to be nvram:/vlan.dat? I know the vlan.dat file is stored in const_nvram: also.

When I try to add a VLAN I get this error:

Error exiting config-vlan mode 38: NV storage failure

So I'm guessing since I don't have a flash card it's trying to write to something that doesnt exist.

1 REPLY
Hall of Fame Super Silver
2317
Views
0
Helpful
1
Replies