These 12 sites are on a Class C Network 192.168.x.x with about 12 VLANS each.
I was instructed to change Everyones Network to a Class A 10.x.x.x and consolidate the 12 VLANS to three vlans.
Vlan 1 Data. Vlan 2 Wifi Vlan 3 Voice.
The problem I am facing is that I find it much easier just to change the first two octects of the network address as suppose to trying to figure out where everything is being routed to and what vlans are using trunking and so forth.
What are some disadvantages and advantages of changing the vlans or keeping the vlans the same just changing ip address.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...