Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vlan discrepancy

We have a cisco 2950-12 switch that is owned and managed by our ISP. We were told that port 1 is VLAN520 and set to full/100.

We plug our own cisco 2950-48 switch from port 32 to that port 1 using a X-over cable.

I then proceeded to define an ip address for vlan520 on our switch:

config t

int vlan520

ip address 172.17.193.12 255.255.255.0

exit

ip default-gateway 172.17.193.1

and also set port 32 to vlan520 and full/100.

int fasteth0/32

switchport access vlan520

speed 100

duplex full

Port 32 starts to blink amber and I can't ping anything.

But once I did a "no switchport mode vlan 520" on port 32, it starts to blink green and i can ping.

So is it safe to say that my ISP has misinformed me about port 1 on the 2950-12, ie, it should be vlan 1, not vlan 520?

2 REPLIES
Gold

Re: vlan discrepancy

maybe your isp has cdp turned on and you can get some insight into how they're configured that way.

on your 2950:

show cdp nei detail

New Member

Re: vlan discrepancy

Switch#sh cdp nei detail

Switch#

Doesn't give me any resulsts when I do this on our 2950-48?

97
Views
0
Helpful
2
Replies