Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

vlan distribution fwsm and ace30

have a new requirement from customer where they want a load balanced solution along with their fw context. Trouble is that the vlans were only specified on the fwsm and now I need them on both the ace and fwsm. I've been told in the past if I just add the vlans to both of the modules I would lose the config on the fwsm context, meaning I would remove it from the vlan-group which only goes to the fw and add it to the vlan-group which goes to both.

has anyone tried this on the fly and not lost the config of the fwsm context allocated to that interface?

from below I need 414 and 515 to be in group 3

svclc autostate

svclc multiple-vlan-interfaces

svclc module 1 vlan-group 2,3

svclc vlan-group 2  14,75,103-107

firewall autostate

firewall multiple-vlan-interfaces

firewall module 8 vlan-group 1,3

firewall vlan-group 1  20,72,200-298,402-417,419-429,434-500,503,513,515-517

firewall vlan-group 3  418,430-433,501,502,504-512,514,600-603

Everyone's tags (4)
246
Views
0
Helpful
0
Replies
CreatePlease to create content