Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

vlan-group synchronization - Cat 6500

How can I achieve synchronization of the Cat 6500 vlan-group definitions. VTP domain only updates the 'sh vlans'

yet, the 'show firewall vlan-group' does not display the assigned vlans.

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: vlan-group synchronization - Cat 6500

Unfortunately you can't, you just have to manually assign them on each switch. It is a pain especially as if the 2 switches have inconsistent vlan-group definitions this can break FWSM failover.

Jon

3 REPLIES
Hall of Fame Super Blue

Re: vlan-group synchronization - Cat 6500

Unfortunately you can't, you just have to manually assign them on each switch. It is a pain especially as if the 2 switches have inconsistent vlan-group definitions this can break FWSM failover.

Jon

New Member

Re: vlan-group synchronization - Cat 6500

After configuring failover on FWSM, the hostname on the secondary unit gets overwritten. Can this be avoided. I would like to identify via the hostname that which one is active.

Regards.

Re: vlan-group synchronization - Cat 6500

Use Prompt command on primary to recongnize which one is active.

prompt hostname context state

Will add sate (primary/secondary) to the prompt.

Your prompt will show you if you are working on an Active or Standby FWSM

HTH

Syed Iftekhar Ahmed

133
Views
0
Helpful
3
Replies
This widget could not be displayed.