Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Vlan ID Translation - Vlan Mapping

Hi all,

I'm having issue in configuring Vlan-to-Vlan mapping.

I'd like to "masking" a Vlan ID "X" in Vlan "Y" for transporting it, using a Layer 2 Trunk starting from a 6500 IOS Switch, to another switch (6500 CatOS)

I used command found on Cisco docs and put them only to the first switch (6500 IOS).

Does anybody know if I must put other IOS command to the second one?

In attachment my switches configuration.

Thanx in adv 4 any help.

1 REPLY
Bronze

Re: Vlan ID Translation - Vlan Mapping

This example shows how to map another VLAN to an existing VLAN group name:

Console> (enable) set dot1x vlan-group engg-dept 4

Vlan 4 is successfully mapped to vlan group engg-group.

I think that the command should be given on the second awitch also with the vlan id of the first switch.

for more information about this command refer:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/command/reference/set_f_l.html#wp1070704

523
Views
0
Helpful
1
Replies