Hey Cisco Goers. My first post here, thanks for the forums.
Going to keep my question brief for now as it is pretty straight forward. Is there a way to gracefully move an IP address on an SVI from one VLAN to another without destroying the IP address?
Interface VLAN 100 has IP 192.168.1.254 255.255.255.0 and I want to move that IP to interface VLAN 500. What I dont want to do is 'no ip address 192.168.1.254 255.255.255.0' on VLAN 100 first then 'ip address 192.168.1.254 255.255.255.0' on VLAN 500.
I suspect no matter how you try this, there's likely going to be some brief impact to active traffic using that IP (if that's what you're trying to avoid).
Even the suggestions using VRFs, which would allow both IPs to be active within different routing topologies is likely to be impactful as other hosts try to use the IP if its intended to be globally unique.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...