In vlan database mode, yes this is the constrain (Only normal-range (VLANs 1-1005) VLANs can be configured in this mode), to use more vlans (extended-range VLANs 1006-4094) you'll need to add them using global configuration.
On the newer IOS switches, such as the 3750s, it's not recommended to use the VLAN database section to configure your VLANs; these should be configured in global config mode, and are created just by typing "vlan ".
WORD ISL VLAN IDs 1-4094
access-map Create vlan access-map or enter vlan access-map command mode
dot1q dot1q parameters
filter Apply a VLAN Map
internal internal VLAN
You should be able to create up to 4094 VLANs in this mode.
Your comment about being a transparent switch is totally correct, but i think that even after the switch is converted into transparent you still need to configure extended vlans in global configuration mode and not in vlan database mode.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.