Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Vlan on 2960

Hi Guys,

I've been googling quite a lot and I still can't figure out what i am doing wrong.

I've a watchguard firewall configured with an interface on a Vlan ID 2. This interface is connected to the port 48 on the Cisco 2960.

I've tried many times to add the port 48 to the VLAN ID 2, but no chance.

in the cisco network assistant, it stays as 'Trunk'.

I have an access point connected to the port 46 on the same cisco switch (watchguard as gateway), and I need to isolate this network as it's for consultants, just don't want them to access our network.

Do you guys have an idea how I could set this up?

Thanks.

1 REPLY
Hall of Fame Super Silver

Re: Vlan on 2960

Hello Florent,

use CLI access

get privileged access

do

sh run int f0/48

copy it on a notepad

conf t

int f0/48

switchport

switchport mode access

switchport access vlan 2

this makes port 0/48 member of vlan2

about second question:

not sure to have understood:

it should be as easy as

put also port 0/46 on same vlan 2 with the commands above.

Edit:

if everything is fine save the config

exit

switch# wr mem

Hope to help

Giuseppe

121
Views
0
Helpful
1
Replies
CreatePlease to create content