cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
552
Views
0
Helpful
2
Replies

vlan pc cannot access to internet

sokmeng.min
Level 1
Level 1

Dear all,

I got a problem with my lab. In this lab there are 1 ASA 5510 (filter internet) and core switch 3560X (for VLAN). I connected and configure the ASA5510 and core switch to each other, as diagram in attachment file, and these device can access internet properly, but the PCs which connected to core switch cannot access inetrnet. This is the diagram and some detail.

Network infrastructur

Please give some advice to solve this problem. Thanks in advance

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

You have 3 vlans (1, 2 and 3) and you are only showing the config for vlan1. Are the other 2 vlans configured with SVIs just like vlan1?

Is firewall doing NAT?

HTH

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

You have 3 vlans (1, 2 and 3) and you are only showing the config for vlan1. Are the other 2 vlans configured with SVIs just like vlan1?

Is firewall doing NAT?

HTH

sokmeng.min
Level 1
Level 1

Dear sir,

Thanks for your reply. Now my vlan client can access to internet, the problem cause of NAT on asa. Firstly, I allow NAT to only one range ( VLAN100: 192.168.100.0/24) which I use to connect from core switch to ASA and now I was change NAT to 192.168.0.0/16 and it work fine. Thanks again for your helpful support.

Best regard,

Review Cisco Networking products for a $25 gift card