Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VLAN priority on the Catalyst 2950 trunk port

Hello!

I have a Catalyst 2950 switch. It have one ethernet port with trunk:

interface FastEthernet0/1

switchport trunk allowed vlan 2,92

switchport mode trunk

spanning-tree portfast trunk

The port is connected on radio-channel with 2 Mbps bandwidth. The Vlan 2 have big traffic every time.

Can i do that all traffic on Vlan 92 will have MIN 64 kbps free bandwidth every time on this radio-channel?

Thanks. Dev

2 REPLIES
Hall of Fame Super Silver

Re: VLAN priority on the Catalyst 2950 trunk port

Hello Dev,

you would need modular QoS to do that and I don't think C2950 supports it

So, I may be wrong, but I don't think you can do it.

Edit:

actually 2950 supports modular QoS inbound so if you can classify and mark traffic on the internal vlans/ports you can then provide some resources to traffic marked in some way.

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22_ea11x/configuration/guide/swqos.html#wp1044930

however, this can work outbound direction only.

on traffic received on fas0/1 you have few to none control.

Hope to help

Giuseppe

New Member

Re: VLAN priority on the Catalyst 2950 trunk port

Ok, I will study this more later. I hope I will can to resolve this problem by QoS

Thanks

192
Views
0
Helpful
2
Replies
CreatePlease login to create content