========== Make the management VLAN a VLAN other than VLAN 1. Keep all user data out of the management VLAN. Instead, configure a loopback0 interface as the management interface on each switch.
The arrangement separates management traffic from user data. The management IP address is in a separate subnet, VLAN, and switch for security. There is higher assurance for management data delivery during network failures. There is no active spanning tree in the management VLAN. Redundancy here is not critical. ==========
Your switch may not be Cat6500/6000 or 4500/4000 but I think it useful information for you.
Thank you for the reply. But my question was apart from the configuration. Probably I was not so cleared according to my question, sorry. My question was, if I need to locate any perticular switch, which is connacted to core switch through VLAN interface, how can I do that. Through cdp neighbour it will not show.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.