09-10-2009 06:29 AM - edited 03-06-2019 07:40 AM
Hi, I set up 2 VLANs on a C4900 switch. VLAN A and B can ping each other.
When server1 from VLAN A sends a tcp Sync to server2 in VLAN B, server2 can get the packet and reply it back to server1, but server1 can't get that backbound packet.
I think it shouldn't be a problem when the vlans are on a layer 3 switch and the switch does the routing, is that correct? TIA.
09-10-2009 06:52 AM
As long as you have ip routing enabled on the switch (you can verify this by typing show ip route and if the routing table is displayed you have routing running), the devices should be able to communicate with each other provided they have the correct IP Subnet and default gateway for their Vlan.
__
Edison.
09-10-2009 07:53 AM
Edison, your comment absolutely clarified my doubt. Thanks a lot.
09-10-2009 06:57 AM
NAT is not supported on the 4900 platform.
Regards,
jerry
09-10-2009 07:54 AM
No, it doesn't support NAT.
And no ACL for these 2 vlans either.
Thanks.
09-10-2009 07:40 AM
Hi
Do you have any ACL's or are you doing any NATing on either vlan?
Thanks
Kev
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide