Primary Secondary Type Ports ------- --------- ----------------- ------------------------------------------
OS Version and type of Switch(L2)
sw1#show version Cisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-I6K2L2Q4-M), Version 12.1(22)EA14, RELEASE SOFTWARE (fc1)
IP address assigned;;
interface Vlan1 no ip address no ip route-cache shutdown ! interface Vlan101 ip address 10.0.1.1 255.255.255.0 no ip route-cache ! interface Vlan102 ip address 184.108.40.206 255.255.255.0 no ip route-cache shutdown ! interface Vlan103 ip address 220.127.116.11 255.255.255.0 no ip route-cache shutdown
Now I cannot ping any of the IP's assigned to the VLAN's. What to do with the VLAN's I've created [stupid and dumb question]. I want to play around the switch and connect it to a Cisco router(I have 5 routers and 5 switches, all different) and create my own lab.
The most important part of this issue is that you are using a layer 2 switch and have created multiple vlans. To route between vlans you need a layer 3 device (could be a router or could be a layer 3 switch).
The other part of the issue is that you have created 3 vlans and associated addresses with them. Your PC is in a different subnet so logically it should be in a fourth vlan. And you need a layer 3 device to route between your PC and the switch subnets/vlans.
you are using L2 switch so the best way that you can ping between different vlans is "router on a stick".
you can change the ip address on your pc for example to 10.0.1.2 255.255.255.0 and 10.0.1.1 as default gateway to establish connectivity to vlan 101. It seems that you set ip address on your wireless card, you must set it on your ethernet card.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...