Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Vlan separation

In my server switch one vlan is creeated and that is 10.101.190.0/24 and firewall is connected then firewall is connected with my core .

i want to some ip address of server series in my core ,

how will be created and how it's possible.

2 REPLIES
VIP Super Bronze

Vlan separation

If all your device are in one subnet (10.101.190.0/24) than you can extend the same vlan to your core and connect your end devices to the core in the same IP range.

HTH

Vlan separation

So the topology is like this?

Server Switch > Firewall > Core?

If so, the only way to extend the subnets across the Firewall is to make it transparent. I am guessing its a routed firewall which means you need a different subnet on each side. If you create the same VLANID on the core and the firewall is in routed mode, it will have problems knowing how to forward packets for that subnet as it will exist on both interfaces,

185
Views
0
Helpful
2
Replies