Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VLAN switchport mode access on 877

Hi

flash:c870-advipservicesk9-mz.124-6.T2.bin

I'm having real trouble getting a working configuration on a Cisco 877 that is to be used for sharing an ADSL connection between two small offices.

The offices will use seperate vlans, 192.168.31.0/24 (vlan1) and 192.168.99.0/24 (vlan2).

I have two cheap Netgear switches, one connected to FE1 (default vlan1) and the other to FE2, where I have issued...

interface FastEthernet2

switchport access vlan 2

switchport mode access

Running 'show ip inter brief' always shows the 'Status' and 'Protocol' as down.

My config is attached, if anyone has any useful suggestions.

Many thanks

Gareth

4 REPLIES

Re: VLAN switchport mode access on 877

Hi

As per the datasheet it supports 4 Vlans with advanced ipservices image.

Would suggest to check whether the other end is up and live.

regds

New Member

Re: VLAN switchport mode access on 877

Hi

Thanks for the reply.

The other end (a 5 port Netgear switch) is up and fine.

If I didn't connect a switch, and just connected my laptop directly into the FE2 port, would the configuration need to change?

I notice that when I issue..

switchport mode access

... on the FE2 interface, it does not stay visible when viewing the running config - is this normal?

Many thanks

Gareth

Silver

Re: VLAN switchport mode access on 877

Hi,

Will you please issue the following commands:

vlan database,

vlan 2,

exit,

and see if there is any improvement.

Best regards,

Antonin

New Member

Re: VLAN switchport mode access on 877

Hi

I entered those commands, but it did not improve the situation.

The FE2 light /led on the front of the router is illuminated, but the IOS shows the status and port as down.

Thanks

Gareth

335
Views
0
Helpful
4
Replies