This is the scenario: I have a Cisco OSR (Cisco 7609 Version 12.2(18)SXF6), and it has several vlans configured.
I need to configure a span port in this OSR, and monitor just two of the vlans (100 and 101). This span port will be connected to a switch catalyst 2960, and then, in this second switch to configure two span ports, one of them will monitor vlan 100 and the other span port will monitor the other one vlan.
The OSR doesn't accept the command you sent yesterday.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...