Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

VLAN Tagging on the router physical interface

HI All

We have a requirement whereby we need to tag the physical interface (please note: not the sub interface) of a router to a particular vlan. I am aware of how to do this on the sub interface and for what I am trying to do, I want to avoid creating the sub interface if I can tag the physical interface with a particular vlan-id.

I am aware of the vlan-id dot1q command but that does not seem to work..

Has anyone done this and if so can they share their experience.

 

Thanks in advance

RK

1 REPLY

IIRC that command is used for

IIRC that command is used for a slightly different purpose, though I am unable to find the documentation on it at the moment. I tried it once and was unable to get it working. As far as I know, you must create a sub-interface to do VLAN tagging on a routed port. Regards, Mike
34
Views
0
Helpful
1
Replies
CreatePlease to create content