It's me again... You guys are helpful and i need your help again. i have multiple vlans (1-8) in my switch catalyst 2950. the trunk port from the 2950 i interfaced in the router 3600(ethernet 0/0) and is used as a gateway to the internet, i would like vlan 2, 4 and 6 to get online. can you give me sample configurations... for 3600 and 7204... Thanks
what if i have different IP addresses in the network. lets say vlan 2 has IP Dslam for the dorms, vlan 4 is for the admin office and vlan 6 is for the sister company of the school that uses ipvpn how can i let all three vlan to connect to the internet?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...