Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VLAN vs. Trunk Configuration

Catalyst 2950s, 3500s, and 2948s

all with standard RJ-45 and 2 Gigabit ports.

8 total. The gigabit ports all connect directly to a 3508G-XL

currently, on the 3508 and all other routers, the gigabit port is configured as part of VLAN 1.

Should I be configuring the gigabit ports on all switches as ISL Trunk, 802.1Q Trunk or keep them as part of the VLAN?

the 2950s use smartport and they have them set to "TRUNK" but it doesnt tell me what type of trunk.

4 REPLIES
Purple

Re: VLAN vs. Trunk Configuration

You don't need to trunk unless you plan on making multiple vlans and plan on propagating those vlans down to switches below the 3508. If trunking it probably better to use the standard of 802.1Q . Unless there is a need for multiple vlans they do need to be trunked .

New Member

Re: VLAN vs. Trunk Configuration

the 2950s assigned the gigabit ports using SmartPort as Trunk

should I switch that back to VLAN1 instead?

Purple

Re: VLAN vs. Trunk Configuration

I would think so , sounds like it is a flat network in vlan 1 .

Silver

Re: VLAN vs. Trunk Configuration

237
Views
0
Helpful
4
Replies