I have two questions, my first is which switch do we need to migrate to? We currently run mostly HP 4000 series switches and I want to replace with a Cisco model with minimal network alterations...
In our current setup each VLAN has a separate IP and default gateway, I've noticed most of the newer switches have one default gateway. The issue at hand is that our DHCP server is giving IP addresses that only VLAN1 are supposed to get, VLAN2-6 are supposed to obtain separate IP addresses.
This leads to my second question; is this the best method? Thanks!
Only Cisco's 2960's have a single default gateway and that is manage the switch and the default gateway is actually on a separate l3 device. . Most of their switches are layer2/3 switches, 3750,4506,6509 etc.. and you can create as many vlans and SVI's as you want which gives each vlan its own default gateway .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...