Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VLAN

Why the required of native VLAN ?

4 REPLIES
Community Member

Re: VLAN

Well Mr. Manjunath,

Native VLAN

When you use the IEEE802.1Q trunkport, all frames are tagged except those on the VLAN configured as the "Native VLAN" for the port. Frames on the Native VLAN are always transmitted untagged are normally received untagged. Therefore, when Access Point is connected to the switchport, the Native VLAN Configured on the Access Point match the Native VLAN configured on the switchport.

Cheers!!!!!!

Community Member

Re: VLAN

Hi,

Can you please send sample configuration for this concept.

Manju.

Hall of Fame Super Blue

Re: VLAN

Manju

The default native vlan is 1. If you wanted to change this you can do the following

int gi2/1

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk native vlan 999

The last line sets the native vlan to be 999.

Jon

153
Views
0
Helpful
4
Replies
CreatePlease to create content