Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Vlans and IPMI

I'm building out a large lab, and I am needing to implement ILO and IPMI since the lab will be a "lights out type environment".

To save ports off my aggregated switches (3750-E's) i'm using IPMI on Dells and for HP i'm using ILO (with the option to enable ILO on the primary Nic).

My ILO/IPMI traffic is on seperate VLAN 223 while my servers can be any 1 of 20 different vlans. How do i set my switch up to route both vlans?

1 REPLY
Hall of Fame Super Blue

Re: Vlans and IPMI

Hi

You need to create a layer 3 SVI (switched virtual interface) for each vlan you want to route eg.

switch(conf t)#interface vlan 223

switch(config-if) ip address "address" "subnet mask"

switch(config-if)# no shut

You might also have to enable ip routing if it isn't already on

switch(conf t)#ip routing

Attached is a link to 3750-E ip routing configuration guide for more details.

HTH

Jon

405
Views
0
Helpful
1
Replies