Can anyone point me in the direction of some examples of VLAN equipment 3550ish switches and a PIX firewall.
I've been trying to ping my firewalls from the inside of my VLAN and from the firewall to the inside of the VLAN and getting know where. I can ping from firewall to the routing port on the 3550. I'm using a /30 address from the PIX e1 to the routing port f0/1 on the 3550. But trying to ping from the other VLANs to e1 address or connecting through telnet from a VLAN to PIX is not working. I dont have any ACLs on the 3550. The PIX has ACLs on the e0 outside interface but not on the inside.
If its easier I can post the configs. this is my first going into production VLAN and it not going like the labs I've done.
that was killing me. I was thinking because I had previously had the 192.168.1.0/24 network that I would not need it the route. But the interface was previously in the class range. I changed it to be a /30 and it didn't know what to do.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...